Share:
Notifications
Clear all
1749da22343b0d85c39164b5c6f52fed?s=150&d=mm&r=g
mappler
Group: Registered
Joined: 2020-10-20
Eminent Member
2
@dsgbros I haven’t done anything with the python app yet u…

In forum Armbot (Arduino OPEN SOURCE robotic arm)

4 weeks ago
I think that section of the code is not used for initial pos…

In forum Armbot (Arduino OPEN SOURCE robotic arm)

1 month ago
Good source for glass in the US

In forum iBoardbot

2 months ago
Camera and LIDAR question

In forum Armbot (Arduino OPEN SOURCE robotic arm)

2 months ago
@robotn1 Ok, the gripper is adjusted MUCH better now. I n…

In forum Armbot (Arduino OPEN SOURCE robotic arm)

2 months ago
Sphere-O-Bot Working!!!

In forum Sphere-O-Bot

2 months ago
I’ve never used an ESP32 board, but I did take a look to see…

In forum Armbot (Arduino OPEN SOURCE robotic arm)

2 months ago
Looks like just bad luck on the servo. The plastic shaft on…

In forum Armbot (Arduino OPEN SOURCE robotic arm)

2 months ago
@robotn1 Yes, it is an SG92R – which now that I think abou…

In forum Armbot (Arduino OPEN SOURCE robotic arm)

2 months ago
@robotn1 Thank you. I’ll work on it this week. -Matt

In forum Armbot (Arduino OPEN SOURCE robotic arm)

2 months ago
I believe the Z calibration is to put the robot at the 200 p…

In forum Armbot (Arduino OPEN SOURCE robotic arm)

2 months ago
Primary construction complete

In forum Armbot (Arduino OPEN SOURCE robotic arm)

2 months ago
Problem compiling Arduino code

In forum Armbot (Arduino OPEN SOURCE robotic arm)

2 months ago
Thanks for this. Just started printing the parts i need to …

In forum Sphere-O-Bot

2 months ago
I did. It is not the nails I was having trouble with (I nev…

In forum Armbot (Arduino OPEN SOURCE robotic arm)

3 months ago
Page 1 / 2
Share: