Unable to upload code to Devia controller board
Recently, my devia controller board isn’t responding. I can see the COM port however, whenever I press upload, the arduino gets stuck
at this statement: forcing reset using 1200 bps open/close arduino zero and never proceed further.
If I press reset button, it searches for COM port then I error as shown in the image.
Also the arm bot software is unable to recognize the devia controller board. I checked serial monitor logs as well, it get stuck after “Timers started” statement.
Please help me.
This is a not horribly uncommon problem with Arduino. Do a Google search for: “forcing reset using 1200bps open/close on port” and you will find many people with similar issues.
Some solutions to look at:
I solved the uploading issue by pressing reset twice. However, now the code gets stuck at
“Timer started” and never proceeded further.
You’re doing better than me. I only get to ‘WIFI Init’
I’ve even tried pressing the reset button three times!
Found a solution that worked for me: