Hi,
I’m currently building the camera slider and have ordered the board for it.
That has now arrived and I have flashed it with firmware v6_M0.
This works without any problems and without an error message.
However, the WiFi did not offer the ID JJROBOTS XX (with password), but an open network AI-THINKER_XX.
The board is not yet installed.
What can I do?
Fred
Did you get any error message when uploading the code? Or any warnings? What arduino IDE are you using? And what SAMD boards library version?
Try this: Install the SAMD driver version 1.8.10. ´8With the Arduino IDE 1.8.6)
I don’t get an error message
After the reset I get this display in the monitor.
This is the SSID that the board sends:
Testet with Arduino IDE 1.8.13 on Windows 10 and IDE 1.8.10 on Unbutu
Fred
Use the Arduino IDE 1.8.6 and the SAMD boards library for the same IDE version or olders (1.8.3 to 1.8.6). They are perfectly stable and compatible. Sometimes, the newest versions are not fully tested will all the possible variations.
Installing that Boards library will allow you to select the GENUINO/ARDUINO ZERO (native USB port) and get over any WIFI compilation warning
That is the reason the DEVIA board is not proramming properly the WIFI module modifying the SSID name to “JJROBOTS_XXX”
Ok, that was the solution.
I downloaded version 1.8.6 of the Arduino IDE and made it to a portable version.
I also installed version 1.8.6 of the board software.
So it worked! Now I’m going to assemble the slider.
Many thanks for the support!
Fred